Videos

How to fit the anti interference board for DJI Zenmuse H3-3D on a Phantom 2

May 14, 2014

How to fit the anti-interference / power filter board for the Zenmuse H3-3D gimbal into a DJI Phantom 2 to prevent FPV interference and allegedly reduce jello?

Mine didn’t come with the gimbal, but arrived in the post the other day forwarded by my supplier. I haven’t had issues with either jello or interference but it was a good excuse to take the lid off the DJI Phantom 2 and have a look at the build quality inside – very nice soldering work in there, well done DJI. Fitting hte board is straightforward but re-routing the cable or cables can be slightly tricky. Should be about a 10 minute job.

My “On the Kitchen Table” videos are mainly aimed at newcomers to multirotors, quadcopters, drones and UAVs, particularly to the DJI product range, and the Phantom line in particular. I have how to’s, product reviews, tips, tricks, hints and information for beginners and those in the early stages of the hobby. I film “on the kitchen table” to show people that, like me, you don’t need a workshop and an array of specialist equipment and years of experience to get started and progress with flying these amazing aircraft and enjoying making great aerial videos and stills. So if you have bought, or are thinking of buying, a DJI Phantom, Phantom FC40, Phantom 2, Phantom 2 Vision or Vision+, or even building your own DJI Flamewheel F450 or F550, we can do it… on the kitchen table!

You Might Also Like

No Comments

Leave a Reply

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible, to facilitate the serving of relevant ads and for site analytics. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close